Instructions:
1. Lay the fabric to be decorated on a hard, flat surface. DO NOT USE AN IRONING BOARD! (diagram 1)
Set your iron to the cotton setting. NEVER USE STEAM! (diagram 2)
Put a piece of plain paper under the fabric to be decorated to protect the surface.
4. Peel off the white protective backing.
5. Inspect the design for any studs that might have shifted, and replace them where they go.
Place the Rhinestud Transfer on to the fabric in the position you want it applied.
Iron the Rhinestuds onto the fabric, applying light pressure with an up and down, and back and forth motion, making sure all areas have been ironed thoroughly. (diagram 3)
8. After approximately 45 sec. you should see the plastic carrier sheet slightly recessed below the studs.
9. After ironing the Rhinestud Transfer onto the fabric, rub it down with a basic cloth or the bottom of the fabric, pressing down gently while it cools to room temperature.
10. When cool, peel off the clear protective carrier sheet.
11. When washing, turn it inside out, gentle cycle, cold water.